Exposed Aggregate Concrete in Melbourne

Exposed aggregate concrete is a decorative concrete finish that reveals the stone or aggregate within the surface. It is commonly considered for driveways, paths and outdoor areas where a textured finish is preferred. The final appearance depends on the selected aggregate, concrete mix, preparation and finishing method used for the project.

Exposed aggregate can be suitable for driveways when the base preparation, concrete specification and site conditions are appropriate for vehicle use. Driveways need to be planned differently from lighter-use paths or outdoor spaces areas. We assess access, levels and the intended load before confirming the practical scope for the property.

Exposed aggregate cost varies with the area, site access, preparation, concrete specification, selected aggregate, edging, levels and overall project complexity. We do not use one generic square-metre figure for every property. A site assessment allows the actual work to be scoped before a clear written quote is prepared.

Yes. Exposed aggregate can be planned alongside outdoor areas, outdoor spaces beds, paths, planting and other hard-hardscape surfaces. We consider the transitions, levels and surrounding materials during the site assessment so the new concrete surface fits the wider property rather than looking disconnected from the outdoor spaces.

Drainage conditions should be considered before any new concrete surface is installed because levels and water movement can affect the surrounding property. The exact requirements depend on the site and proposed work. Where civil, drainage or approval requirements extend beyond general hardscaping, the appropriate specialist or authority should confirm what applies.